1 technical data sheet 75 ohm smc jack bulkhead connector clamp/solder attachment for rg180, rg195, .285 inch d hole confguration connector smc jack connector interface type rg180,rg195 cable attachment method (shield/contact) clamp/solder body style straight mount method bulkhead electrical specifcations impedance, ohms 75 mechanical specifcations size length, in [mm] 0.845 [21.46] width/dia., in [mm] 0.342 [8.69] . weight, lbs [g] 0.013 [5.9] connector type smc jack contact material and plating gold body material and plating brass, nickel dielectric type ptfe compliance certifcations (visit www.pasternack.com for current document) rohs compliant y es plotted and other data notes: v alues at 25 c, sea level 75 ohm smc jack bulkhead connector clamp/solder attachment for rg180, rg195, .285 inch d hole from pasternack enterprises has same day shipment for domestic and international orders. our rf, microwave and fber optic products maintain a 99% availability and are part of the broadest selection in the industry. click the following link (or enter part number in search on website) to obtain additional part information including price, inventory and certifcations: 75 ohm smc jack bulkhead connector clamp/solder attachment for rg180, rg195, .285 inch d hole PE4283 url: http://www.pasternack.com/smc-jack-standard-rg180-rg195-connector-PE4283-p.aspx PE4283 PE4283 rev 01 75 ohm smc jack bulkhead connector clamp/solder attachment for rg180, rg195, .285 inch d hole
? 2013 pasternack enterprises all rights reserved 2 PE4283 rev 01 scale n/a dwg title cad file 2233 fscm no. 53919 rev. - 042409 size a PE4283 notes: 1. unless otherwise specified all dimensions are nominal. 2. all specifications are subject to change without notice at any time. 3. dimensions are in inches [mm]. 4. fits mil-c-17 and equivalent cables. 1. slide clamp nut (1) over cable. strip cable as shown in a. slide compression washer (2) over braid & seat against jacket. flair braid over compression washer (2). 2. slide braid clamp (3) over dielectric & under braid. push into washer until it stops. strip cable as shown in b. trim excess braid flush with surface of compression washer (2). insert insulator (4) over dielectric with center conductor protruding through hole. 3. solder contact (5) to center conductor. insert cable assembly into body & tighten. assembly procedures 75 ohm smc jack bulkhead connector clamp/solder attachment for rg180, rg195, .285 inch d hole PE4283 cad drawing
|
